ThermoWorks USB TEMPERATURE & HUMIDITY DATA LOGGERS - Handbuch (Seite 13)

*If the logger is set to ‘LCD off’ or ‘LCD on for 30 seconds’ mode, then this will only be shown after
the button is pressed. Otherwise the display will remain blank.
Explanation Logger status Display
Delayed Start
Push to Start
Logging
Stopped
This is shown when the logger is set to
start at a specific date and time *
This is shown when the logger is setup for
‘push to start’ logging
This is shown when the logger is running
in ‘LCD off’ mode, and the button is
pressed. The display clears again after
three seconds
If the logger has not been set to log and
the button is pressed, three dashes are
displayed for three seconds
10
thermoworks inst and op guidev1.1 hk(version).qxp 17/12/2008 10:32 Page 13