Denon AVC-A1XV - Handbuch (Seite 8)

System Setup System Setup
7
ENGLISH
ENGLISH
Setting the Network Setup
• “Network Setup” is added to the “Option Setup” items at “System
Setup Menu”.
• If you are using a broadband router (DHCP function), there is no
need to make the settings at “IP Address” and “Proxy”, since the
DHCP function is set to “ON” in the AVC-A1XV’s default settings.
• If the AVC-A1XV is being used connected to a network without the
DHCP function, the network settings must be made. In this case,
some knowledge of networks is required.
Press D D H H to select “Network Setup”, then press
ENTER .
IP Address:
Set the IP address within the ranges shown below. The Network
Audio function cannot be used if other IP addresses are set.
CLASS A: 10.0.0.0 ~ 10.255.255.255
CLASS B: 172.16.0.0 ~ 172.31.255.255
CLASS C: 192.168.0.0 ~ 192.168.255.255
1
Setting the IP Address
Press D D H H to select “IP Address”, then press ENTER . 2
Press F F G G to select “OFF”.
• The DHCP function is disabled.
3
Press D D H H to select the desired setting item, then
press G G D D H H to input the address.
4
Subnet Mask:
When connecting an xDSL modem or terminal adapter directly to
the AVC-A1XV, input the subnet mask indicated in the
documentation supplied by your provider. Normally input
255.255.255.0.
Gateway:
When connected to a gateway (router), input its IP address.
Set this when “OFF” is set for “DHCP”.
Press ENTER . 5
Primary DNS / Secondary DNS:
If there is only one DNS address indicated in the documentation
supplied by your provider, input it at “Primary DNS”. If there are
two or more DNS addresses, input the first one at “Second DNS”.
The resolution (“Resolution”) can be changed by pressing SCALE.
Press SCALE .
When SCALE is pressed, the current setting is shown on the
display. If SCALE is pressed while the current setting is displayed,
the “Resolution” setting can be changed.
• When “HDMI” is selected for the “Scaler” setting:
1080p Through
480p/576p 1080i 720p
Through
480p/576p 1080i 720p
• When “Component” is selected for the “Scaler” setting:
Selection of resolution setting (SCALE)
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
SCALE ENTER D H F G
ENTER
D H F G
SCALE
1.AVCA1XVE2_UP_ENG 06.4.6 1:26 PM Page 7