AMT Datasouth Fastmark M4 - Handbuch (Seite 46)

~ 46 ~
Continued on next page
Item Description Default
Density
Use this item to setup printing darkness. The available
setting is from 0 to 30, and the step is 1. You may need
to adjust your density based on selected media.
16
Print Speed
Use this item to setup print speed. The each increase or
decrease is 1 ips. Available setting is from 1 to 6.
2
Tear Off
This item is used to fine tune media stop location.
Available setting value is “+” or “-” from “0” to “9”.
+000
Print Mode
Printer Mode Description
Tear Off
Tear Off Mode Next label top of form is aligned to the
print head burn line location.
Peeler Mode Enable the label peel off mode.
The above options are used to set media present modes.
Print Width
This item is used to set print width. The available value is
from “0” to “9”.
812
List Fonts
This feature is used to print current printer available fonts
list to the label. The fonts stored in the printer’s DRAM,
Flash or optional memory card.
N/A
List Images
This feature is used to print current printer available
images list to the label. The images stored in the printer’s
DRAM, Flash or optional memory card.
N/A
List Formats
This feature is used to print current printer available
formats list to the label. The formats stored in the
printer’s DRAM, Flash or optional memory card.
N/A
List Setup
This feature is used to print current printer configuration
to the label.
N/A
Control
Prefix
This feature is used to set control prefix character. N/A
Format
Prefix
This feature is used to set format prefix character. N/A
Delimiter
Character
This feature is used to set delimiter character. N/A