Clearaudio Universal (Radial) - Handbuch (Seite 5)

Universal
9“ / 12“
User manual / Bedienungsanleitung
Seite/Page 5  clearaudio electronic GmbH 2015
2. Universal
(9” and 12”)
– tonearm mounting
Please keep in mind that the following instructions are covering the mount of the
Universal tonearm on any Clearaudio turntable. Installation on other brand turntables is
possible but not covered in this manual.
Please refer to the turntable manufacturer´s user manual.
2.1 Universal tonearm with VTA – Lifter:
1).
Slide the VTA-Lifter into the drilling of the tonearm base. Lock the VTA-Lifter with the screws
on the side of the tonearm base (pic. 3 and 4).
To adjust the height of the tonearm in the
VTA-Lifter lift the VTA-Lifter up and loosen the
screws.
After adjustment of the tonearm height tighten
the screw again.
Pic. 2: Universal with VTA-Lifter
Pic. 3: Set-up of tonearm base with VTA-Lifter
Pic. 4: Adjustment of the height of tonearm with VTA-Lifter