Dometic 960 Series SaniPottie - Handbuch (Seite 7)

7
“MsD” perManent installation
portable toilets are legally acceptable for use in vessels not having permanently installed toilets, as determined by the united
states Coast Guard. However, some states and the Canadian province of ontario require a permanently installed portable toilet,
such as the 964msD and 965msD.
installation possibilities
Hold down brackets are provided as standard equipment with marine models or may be purchased separately to secure your rV
sanipottie ® portable toilet in the desired location. the following instructions are provided as a guideline for your convenience.
. position sanipottie ® portable toilet in desired location. make sure of
adequate clearance for lid and seat in up position and clearance at the
sides to unlatch and remove top tank.
2. open side clasps by pulling outward at top of side clasps.
3. place hold down brackets, with mounting holes facing away from toilet,
under the tank and align with grooves. see Figure .
4. use pencil or awl to mark location of hold down bracket mounting holes.
5. remove sanipottie ® portable toilet.
6. Attach hold down brackets to the floor or deck with screws provided.
7. set sanipottie ® portable toilet between brackets and latch in place with side clasps.
installinG HolD DoWn braCKets
Figure 
Dockside pumpout
Direct overboard Discharge to remote Holding tank
-/2” Deck waste Fitting
2” Hose Clamp
3/4” Hose Clamp
3/4” Hose Clamp
5/8” Vent Fitting
(included with sanipottie)
5/8” Vent
Hose
5/8” thru-hull Vent Fitting
(installed above water line)
sealand no. 34287
odorsafe plus
sanitation Hose
-/2” swivel nut
(included with sanipottie)
-/2” Gasket
(included with sanipottie)
-/2” Hose adapter (in-
cluded with sanipottie)
sanipottie ® 964MsD/965MsD rear View
remove Cap From bottom
tank Vent adapter
Fresh water tank
Holding tank
remove -/2” Cap & plug
From bottom tank waste
Discharge adapter
sanipottie ® 964MsD/965MsD