Dirt Devil MAGNUM MPR - Handbuch (Seite 24)

24
3 Operating
Vacuuming
Proceed as follows to attach the nozzles:
1. Switch the appliance off and pull the plug out of the
socket.
2. Remove the nozzle from the telescopic tube (Fig. 9/1).
3. Push the desired nozzle onto the lower end of the
telescopic tube (Fig. 9).
4. Secure the nozzles no longer required in the
accessories mount, as far as this is possible. Keep the
other nozzles safe and inaccessible to children.
3 Operating
3.1 Vacuuming
.
WARNING:
Only assemble the nozzles if the plug has been removed
from the socket. The cylinder vacuum cleaner could be
switched on by accident.
Fig.9
1
WARNING:
Check the cylinder vacuum cleaner and the power cable
before each use. A damaged appliance must never be
used. There is a risk of injury.
ATTENTION:
Only use the cylinder vacuum cleaner if all filters are
correctly in place and once you have ensured that no
openings are blocked The filters must not be damaged
and must be dry. Non-compliance can damage the
cylinder vacuum cleaner.
NOTE:
The cylinder vacuum cleaner has an overheating
protection device. It automatically switches off if it is
overheated (e.g. from blocked nozzles or if the dust
container is too full). If this happens, then turn off the
cylinder vacuum cleaner and remove the plug. Remove
the cause of overheating. Wait approx. 45 minutes. Once
the cylinder vacuum cleaner has cooled down you can
switch it on again.
02Centrixx_Retro_gb.book Seite 24 Freitag, 23. Februar 2007 11:28 11