AXING EoC 1-00 - Handbuch (Seite 28)

Operation Instructions | EoC 1-01 | Ethernet over Coax
12 2015-06-30 | © AXING AG Schweiz | Konstrukions -, Typenänderung, Irrtümer und Druckfehler vorbehalten
5. Troubleshooting
5.1. LEDs
LEDs
The LEDs indicate an "activity" and are used for troubleshooting.
Power LED off
 Make sure that the network cable is connected correctly.
 Make sure that the mains switch of the EoC modem is switched on.
LAN LED is not flashing
No data traffic. Check the following:

Are the router and the modem switched on?
 Is the Ethernet cable connected firmly to the LAN port of the router/modem?
 Can the PC - connected to the router - establish a connection to the Internet?
 Press the EoC Reset button on each EoC modem for 10 seconds to restore the factory settings of the EoC
modem.
 If necessary generate a new network key (see chapter 4 on page 12).
EoC LED off - is not lit
The EoC devices cannot be found.

Make sure that the EoC devices are connected to the same antenna network and that they use the same
network key.
 Position the EoC modem closer to the computer or the EoC modem.
 After having activated the network security, make sure that all EoC modems use the same network key.
 If the problem occurs, after the network key has been changed, re-establish the factory settings of each
device again. Then, you can generate the key again (see chapter 4 on page 12).
 Check whether your antenna system provides a return channel.
EoC-LED is lit in red
 The line attenuation between the EoC modem is too high. Position the EoC modem closer to the master
device.