Parkside PRESSURE WASHER BRUSH ATTACHMENT - Handbuch (Seite 5)

5
Pressure Washer Brush
Attachement
Rated pressure max. ....110 bar / 11 MPa
Max. pressure .............160 bar / 16 MPa
Max. pumping rate, water........... 450 l/h
Initial Operation
Screw the brush (5) onto the bottom exten-
sion pipe (4). Screw the bottom extension
pipe (4) onto the top extension pipe (3).
Plug in and twist to connect the pressure sc-
rubber to the spray gun of your PHD 150
B2 / PHD 150 A1/ PHD100 B2 /PHD
100 A1 pressure washer via the high pres-
sure connection on the gun side (1). Screw
the cap nut (2) against the spray gun for a
firm grip.
On all surfaces, test the brush (5)
initially on a location that is not
visible, in order to ensure compati-
bility.
Removal of the pressure scrubber is in the
reverse order. Start by loosening the cap
nut (2). Then push and turn the pressure sc-
rubber in the opposite direction to separate
the pressure scrubber from the spray gun.
• Store the equipment in a frost-proof
room.
Guarantee
Dear Customer,
This equipment is provided with a 3-year
guarantee from the date of purchase.
In case of defects, you have statutory rights
against the seller of the product. These
statutory rights are not restricted by our
guarantee presented below.
Terms of Guarantee
The term of the guarantee begins on the
date of purchase. Please retain the original
receipt. This document is required as proof
of purchase.
If a material or manufacturing defect
occurs within three years of the date of
purchase of this product, we will repair or
replace – at our choice – the product for
you free of charge. This guarantee requires
the defective equipment and proof of pur-
chase to be presented within the three-year
period with a brief written description of
what constitutes the defect and when it oc-
curred.
If the defect is covered by our guarantee,
you will receive either the repaired product
or a new product. No new guarantee pe-
riod begins on repair or replacement of the
product.
Guarantee Period and Statutory
Claims for Defects
The guarantee period is not extended by
the guarantee service. This also applies for
replaced or repaired parts. Any damages
and defects already present at the time of
purchase must be reported immediately af-
ter unpacking. Repairs arising after expiry
of the guarantee period are chargeable.
Guarantee Cover
The equipment has been carefully pro-
duced in accordance with strict quality
guidelines and conscientiously checked
prior to delivery.
The guarantee applies for all material and
manufacturing defects. This guarantee
does not extend to cover product parts
that are subject to normal wear and may
therefore be considered as wearing parts
(e.g. impeller, collection bag and carbon