Parkside PDMH 4500 A2 - Handbuch (Seite 7)

7 GB/IE
Introduction Introduction / General safety instructions for air tools
Technical Data
Max. working pressure: 6.3 bar
Percussion rate: 3500 rpm
Chisel holder: 11 mm
Weight:
Hammer:
1390 g
Noise and vibration
Noise and vibration ratings were determined according
to EN 15744 and EN 28927-9.
Noise level L
pA
: 96.8 dB(A)
Uncertainty K
pA
: 3 dB
Sound power level L
WA
: 107.8 dB(A)
Uncertainty K
WA
: 3 dB
Wear hearing protection!
Exposure to noise can cause hearing loss.
Vibration
Vibration emission value a
h
= 6.14 m / s 2
Uncertainty K = 1.5 m / s 2
Additional information
The vibration emission value specified was measured
according to a standardised testing method and may
vary depending on the method the tool is being used,
and in exceptions be higher than the specified value.
The vibration emission value specified can be used
to compare tools.
The vibration emission value specified can also serve
as a preliminary assessment of the impact.
General safety
instructions for air tools
Note: When used in the following text, the terms
„compressed air unit“ or „device“ refer to the com-
pressed air unit specified in these instructions for use.
Basic safety measures must be
followed when using compressed air devices to elim-
inate the risk of fire, electric shock and personal in-
jury. Be sure to read and follow the notices within
these instructions for use prior to using the equipment
and store them in a safe location. The manufacturer
assumes no liability for damages or personal injury
resulting from failure to follow these instructions for use.
Persons (including children) who lack the knowl-
edge or experience to use the tool or whose
physical, sensory or intellectual capacities are
limited must never be allowed to use the tool
without supervision or instruction by a person
responsible for their safety.
Ensure children do not play with the device.
RISK OF INJURY! Before
performing maintenance tasks, disconnect the
compressed air supply.
EXPLOSION HAZARD! Never use
petrol or other flammable liquids to
clean the air tool! Sparks could ignite
residual vapours inside the compressed air unit
resulting in the compressed air unit exploding.
Do not use the device in explosive environments
with flammable liquids, gasses or dust. Never
work on materials which are or could potentially
be highly flammable or explosive.
Only use the equipment in areas of application
for which it was designed!
Do not overburden the device.
Never use hydrogen, oxygen, carbon
dioxide or other bottled gasses to
power this tool as doing so may re-
sult in an explosion and thus may cause severe
injuries.
Regularly maintain and clean the device as
specified (see chapters „Maintenance“ and
„Cleaning and care“).
Inspect the device for any damage before use.
Always make sure that the device is in perfect
condition each time before use.
Always be attentive! Unexpected movement of
the device may cause hazards.
Avoid placing your body in an unnatural position.
Keep proper footing and balance at all times.
By doing this you will be in a better position to
96912_par_Druckluft-Meisselhammer PDMH 4500 A2_content_FI.indd 7 03.06.14 15:08