Parkside PDS 290 A1 - Handbuch (Seite 26)

26 GB
Always pull the mains plug is
out of the socket before doing any work on the
device.
Q Adapter for external vacuum
extraction (with reducer piece)
connection:
Push the adapter for external vacuum extrac-
tion
7 into the dust extraction spout 4 .
When doing this observe the guide markings
on the device and adapter. Turn the suction
nozzles clockwise to lock.
If it is necessary to use the reducer piece 8 ,
push the reducer piece into the adapter for
external vacuum extraction
7 .
Push the hose of a suitable dust extraction de
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
7 or the reducer piece 8 .
Removal:
Pull the hose of the dust extraction device off
the adapter for external vacuum extraction
7 .
Turn anticlockwise to unlock the dust extraction
port
4 .
Pull off the adapter for external vacuum extrac-
tion
7 (with the reducer piece 8 if used).
Q
Attaching / detaching
sanding sheets
Always pull the mains plug is out
of the socket before doing any work on the device.
Attaching:
Sanding sheets are attached to the backing plate
6 by means of the hook and pile fastening.
Detaching:
Simply pull the sanding sheet off the backing
plate
6 (see Fig. B).
Materials:
Wood (sanding sheets included), paint*, stone*
*depending on the sanding sheet
Q Turn the backing plate
in 60° steps
Always pull the mains plug out
of the socket before doing any work on the device.
Turn the backing plate 6 of the delta sander
in 60° steps until it engages in the desired
position (see Fig. C).
Sanding output and surfaces:
The shape of the delta sander allows you to sand
workpieces even in their difficult to access places,
corners and edges (see Fig. D).
Sanding performance and surface quality depend
on the grade of sanding sheet and the oscillation
speed setting.
Always use sanding sheets with grades that
are suitable for the particular surface you are
sanding. The speed selected should also be
appropriate to the task undertaken.
Q Advice on use
Switch the device on before placing it against
the workpiece.
Apply light sanding pressure only.
Advance the device at an even rate.
Change sanding sheets at the appropriate time.
Do not work on different types of material using
the same sanding sheet (e.g. wood and then
metal). To achieve the best sanding results you
should use unworn, undamaged sanding sheets.
Clean the sanding sheet from time to time with
a vacuum cleaner.
Q
Maintenance and cleaning
Always pull the mains plug out
of the socket before doing any work on the device.
The delta sander is maintenance-free.
Clean the device frequently. This should be done
immediately after you have finished using it.
For cleaning the housing use a dry cloth only.
Remove any adhering sanding dust with a nar-
row paint brush.
Preparing for use / Maintenance and cleaning Maintenance and cleaning / Service centre / Warranty / Disposal