Auriol 2-LD3564 - Handbuch (Seite 3)

- 3 -
place. Improper use of batteries may cause an explosion
or leakage. If the batteries have leaked, use gloves and
clean the wristwatch thoroughly with a dry cloth.
- The wristwatch should not be in the hands of
children
Never let children use electrical devices unsupervised.
Children can’t always recognize the possible dangers
properly. Batteries/ rechargeable batteries can be life
threatening when swallowed. Store the batteries where
they cannot be reached by small children. If a battery is
swallowed, medical aid must be sought immediately.
Also keep the packaging foils away from children.
Danger of suffocation.
Features
Setting the normal time
Before setting the time, ensure that all stopwatch hands
are at the "0" position and do not push the buttons as this
will change the position of the stopwatch hands. Pull the
crown out to the 2
nd stop when the second hand reaches
the 12 o'clock position. Set the time by turning the crown
clockwise. Press the crown back to the initial position.
Setting the date
Pull the crown out to the 1 st stop- turn the crown clockwise
to set the correct date. Press the crown back to the initial
position. The date will change between 23:30 and
24:00. If the date changes between 11:30 and 12:00,
Turning
bezel 24 hours
Stopwatch
minutes
Stopwatch
seconds Date
- 4 -
adjust the time by 12 hours.
Do not set the date between 9:00 pm and 1:00
am as this can cause damage to the movement.
Stopwatch feature
Press button A to start the stopwatch- press Button A
again to stop the stopwatch. You can now read the
stopped time. Press Button B to reset the hands to the "0"
position.
The stopwatch can measure a time span of up to 60
minutes.
Lap time measurement
Press button A to start the stopwatch- press button B to
stop the stopwatch and read the lap time, the stopwatch
will continue to count internally. Press button B again to
show the running stopwatch time. This process can be
repeated as often as desired. Press A to stop the
stopwatch and read the stopped time.
Adjusting the stopwatch hands
If the small stopwatch hands are not exactly in the "0"
position (12 o'clock position) they must be adjusted
manually. Carefully pull the crown out all the way to the
stop. Repeatedly press button A to move the second hand
of the stop watch back to the 0 position. The minute hand
of the stop watch can be moved by pressing and holding
button B- in this case the second hand will also move.
Press the crown back to the initial position.
Water resistance
Water resistant up to 10 bar. The bar value specifies the
atmospheric overpressure which is applied during testing
(DIN 8310).