Auriol 2-LD3493-1 - Handbuch (Seite 3)


- 7 -
1. At the buckle (see fig. 1.)
Unlock the safety cover (if applicable) and open the buckle. The strap is held in position by a spring bar. The spring
bar can be compressed with a pointed tool to enable shortening of the strap. Move the strap to the desired position
and allow the spring bar to lock into place.
2. At the strap (see fig. 2)
Shortening of the strap can also be achieved by removing segments. Open the buckle and remove the spring bar as
described in part 1.
Place the wristwatch on a soft surface with the dial facing downward. The segments that can be removed are
marked with an arrow. Push a pointed tool into the opening on the backside of the strap and push the bolt out of the
strap in the direction of the arrow. Pull out the bolt (you may need to use tweezers).
The strap can now be disassembled.
Remove as many segments as necessary in the described fashion and reassemble the strap by pushing the bolt
inwards in the opposite direction of the arrow. Reassemble the buckle with the spring bar.
Replacement of battery
(2-LD3493-1 = CR2016)
Battery replacements must be performed by an expert to avoid damaging the case or gaskets.
Troubleshooting
If your watch displays an incorrect time, this can have different causes.
1. 1. 1. 1. The displayed time differs from the actual time by exactly one or more hours. The minutes are correct.
Restart radio reception first. See "Manually initiate radio reception".
The incorrect time zone may be set. Follow the instructions in the chapter "Changing the time zone".
If the problem persists, follow the instructions in the chapter "Reset and calibration".
2. 2. 2. 2. The time differs by one or more minutes and possibly hours.
Restart radio reception first. See "Manually initiate radio reception".
Follow the instructions in the chapter "Reset and calibration".

- 8 -
Cleaning instructions
Clean the wristwatch with a soft, dry and lint-free cloth. A glasses cleaning cloth is ideal.
Disposal of the watch
This wristwatch may not be disposed of with normal household waste. Dispose of the wristwatch at an
approved disposal facility or at your local recycling centre. Please observe the current rules and
regulations when disposing of the watch. Contact the disposal system if in doubt.
Disposal of the batteries
Please dispose of your batteries properly in containers especially set up at retailers. Batteries do not
belong in household waste. Dispose of the batteries at an approved disposal facility or at your local recycling
centre. Contact the disposal system if in doubt.
Declaration of Conformity
If used as intended this product conforms to the basic standards of § 3 and the other relevant provisions of the FTEG
(Section 3 of the R&TTE directive). The declaration of conformity may be requested here: conformity@digi-tech-
gmbh.com
digi-tech gmbh warranty
This wristwatch includes a 3 year warranty starting on the day of purchase. In case of defects of this wristwatch you
have, by law, certain rights regarding the vendor of the watch. These rights are not changed by the warranty which
is described in the following paragraphs.
Warranty conditions
The warranty duration starts on the date of purchase. Please keep the original receipt in a safe place. The receipt is
needed as a proof of purchase. If a defect occurs in the wristwatch within 3 years, the wristwatch will be repaired or
replaced (according to our choice) free of charge. This warranty requires that, within the 3 year warranty period,
the wristwatch and the receipt can be made available to us along with a short written description of the defect and
when it occured. If the defect is covered by the warranty, you will receive the repaired wristwatch or a new watch.
Repair or replacement does not cause the warranty period to restart.

- 9 -
Warranty period and defects liability
The warranty period is not increased by the defect liability. This also applies to repaired or replaced parts. If defects
are noticed at the time of purchase they must be reported immediately upon unpacking the item. Paid repair may be
available after the end of the warranty period.
Scope of the warranty
The wristwatch was manufactured according to strict quality guidelines and was carefully inspected before delivery.
The warranty does not include parts that experience normal wear and tear and can thus be seen as wear parts or
fragile parts that are damaged. Examples include Switches, Batteries or parts made of glass.
This warranty becomes void if the wristwatch is damaged, is not used in the recommended way or is improperly
repaired. For proper use of the wristwatch all instructions in this manual must be adhered to exactly. Use of the
wristwatch in a way that is discouraged in the manual must be avoided.
The wristwatch is not intended for commercial use. Abusive or improper use, excessive force and changes that are
made by non-authorized repair centers will void the warranty.
Warranty claim procedure
To ensure that your call is processed in a fast and efficient manner please note the following directions:
• Have your receipt (as proof of purchase) and the article number (89492) handy.
• The article number can be found on the type label, an engraving, the front page of the manual (bottom left) or a
sticker on the back side or bottom side of the case.
• In case defects occur, please first contact the service center (see below) by phone or email.
Visit www.lidl-service.com to download this and many other manuals,
product videos and software.

- 10 -
Service
Name: inter-quartz GmbH
Email: [email protected]
Telephone: 00800 5515 6616
Based in: Germany
00800 5515 6616
00800 5515 6616
00800 5515 6616
00800 5515 6616
800 5515 6616
IAN 89492
Supplier
Please note that the following address is not a service address.
Please first contact the service address (see above).
Name: digi-tech gmbh
Street: Valterweg 27A
Town: Eppstein 65817
Country: German y