Florabest FKS 2200 C2 - Handbuch (Seite 65)

65
GB
Q
4.. Felling.back.cut..(B):
Make the back cut from the other
side of the log, where you stand
to the left of the log and saw with
the chainsaw pulling. The back
cut must run horizontally 5 cm
above the horizontal notched cut.
The back cut should be so deep
that the separation distance be-
tween the back cut and the notch
cutting line is at least 1/10 of the
trunk diameter. The part of the
log not sawed through is desig-
nated as a break dimension.
R
Insert a felling wedge or a crow-
bar into the back cut, as soon as
the depth of cut permits this, in
order to prevent a jamming of the
chain bar.
S
5. If the trunk diameter is larger than
the length of the chain bar, make
two cuts.
. For.safety.reasons,.we.ad-
vise.inexperienced.users.not.
to.fell.any.logs.with.a.rail.
length.which.is.smaller.than.
the.trunk.diameter.
. 6. After carrying out of the back cut,
the tree falls by itself or with the
aid of the felling wedge or crow-
bar.
. As.soon.as.the.tree.begins.to.
fall,.pull.out.the.saw.from.the.
section,.stop.the.motor,.place.
the.electric.chainsaw.down.
and.leave.the.workplace.us-
ing.the.withdrawal.path..
Maintenance and
cleaning
. Basically,.carry.out.mainte-
nance.and.cleaning.works.
with.switched-off.motor.and.
power.plug.removed..Danger.
of.injury!.
Leave.any.maintenance.and.
servicing.work.not.covered.
by.this.manual.to.our.Serv-
ice-Center..Use.only.original.
spare.parts...
Allow.the.machine.to.cool.
down.before.all.maintenance.
and.cleaning.works..Danger.
of.burn.injuries!
Cleaning
• Clean the machine thoroughly after
every use. In this way, you extend the
life of the machine and avoid acci-
dents.
• Keep the gripping handles free of pet-
rol, oil or grease. Clean the gripping
handles, where appropriate, with a
moist cloth soaked in soap. Use no sol-
vents or petrol for cleaning!
• Clean the saw chain after every use.
Use a paint brush or wipe for that. Do
not use any liquids to clean the chain.
After cleaning, oil the chain lightly with
chain oil.
• Clean the ventilation slots and the
surfaces of the machine with a paint
brush, whisk or dry cloth. Do not use
any liquids for cleaning.