Working instructions – Florabest FBM 450 A1 Benutzerhandbuch

Seite 35

Advertising
background image

35

GB

For your safety: Stand behind the

device when starting it.

Check the petrol and oil levels regu-

larly (see “initial operation”) and

refill in time.

Cold start:

1. Press the petrol pump (32)

(primer) 3 x.

2. Pull the safety loop (2)

towards the grip handle

(1) and hold it.

3. Pull the starter handle (7).

4. If the motor starts slowly, release

the starter handle into the starter

rope-guide (3).

For a warm start it is not necessary

to press the primer (32).

If the primer is pressed too often,

too much petrol will enter the car-

burettor and the motor is difficult to

start.

Motor stop:

• Release the safety loop (2). The motor

switches off and the knife is braked.

Knife stopping device:

Regularly examine the knife stopping de-

vice:

Release the safety loop (2). The motor

switches off and the knife is braked. The

knife must stop within 7 seconds.

Mowing

1. Start the engine (see

).

2. Hold the grip handle (1) and the

safety loop (2) with both hands

while mowing.

Working Instructions

General Working Instructions

• As far as possible, mow the lawn when

it is dry in order to protect the turf.

• Set the cutting height such that the

equipment is not overloaded.

• Run the equipment at walking speed in

lines that are as straight as possible. For

uninterrupted mowing, the lines should

always overlap by a few centimetres.

• Do not move backwards.

• On slopes, always work across the

slope.

• If the blade comes into contact with

a foreign body, switch off the engine

immediately. Wait until the blade is

stationary and check the equipment for

damage. Restart work only if the equip-

ment is undamaged.

• Switch off the equipment during longer

breaks and for transportation and wait

until the blade is stationary.

• Clean the equipment after each use, as

described in the “cleaning and mainte-

nance“ chapter.

Setting the Cutting Height

The equipment has 5 positions for setting the

cutting height (25-75 mm):

1. Pull the lever (17) outwards and

push it to the desired position

(33).

2. Push the lever (17) back in.

Advertising