Ultimate Speed Z30454 - Handbuch (Seite 5)

7 GB/CY
... / Assembly / Instructions for use of accessories / Maintenance and care / Disposal

The tyre stand may not be moved when sup-
porting a load (rims + tyres) since there is a
danger that it could tip over.

The tyre stand may not be tipped since this
could cause injury.

The tyre stand may not be used if damaged
since this could cause injury.

Always operate the tyre stand using two
hands.
   Due to danger of tipping,
load tyre stand ONLY from
above, in order to avoid
injury.
 Assembly
Decide on the final location for your rim tree before
putting the wheels on to it.
1) First of all fit the central linking piece and the
extension legs together. Fasten with the screws
(Contents: pos. 2) supplied (if necessary a rub-
ber hammer can help with this). Then fit the
end stoppers.
2) Insert the down rod section (without plug) into
the central linking piece. Put the pin through
the lowest hole and fit the plate.
3) Load rim with tyre. Proceed in same sequence
for other tyres.
4) Now, put in place end rod section (with stop-
per). Proceed as described above, until all 4
tyres are properly stored.
5) If you would like to make use the storage con-
tainer for storing assembly items, carefully re-
move the stopper from the end rod section
(e.g. with the aid of a screwdriver). Place the
storage container on the end rod section.
Notes: the two individual parts of the storage
container must be joined with the correspond-
ing screws (Contents: pos. 9) before being
used. For this, please use a crosshead screw-
driver, size PH1.
 Instructions for use
of accessories
The tyre chips are placed on the valves as a simple
means of labelling when storing tyres.
The air pressure gauge is used for taking rough
measurements. If needed, go to the nearest petrol
station to check the pressure more accurately.
Use: push in the measuring rod of the air pressure
gauge fully before use. Then place on valve and
read off pressure in desired units on the measuring
rod. If the pressure is too high, the valve can be
pressed in using the button on the side of the
gauge to let out air. The tread gauge is used for
taking rough measurements. Go to a garage if
necessary. The required profile measurements may
vary by country. Therefore please find out about
the specific regulations in your country.
The storage container is for the storage of assem-
bly accessories.
 Maintenance and care

The tyre stand should be checked regularly for
damage or wear. If any defects are found it
should not be used.

Use a damp cloth for cleaning. Do not use any
cleaning fluids, solvents or sharp objects.
 Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
Description of product:
Tyre stand
Model no.:
Z30454
Version: 1
Y / 201Y
53355_uls_Felgenbaum_Content_LB7.indd 7 19.10.10 12:27