Livarno Energy-Saving Ceiling Lamp - Handbuch (Seite 23)

23 GB
Prior to installation / Mounting / Start-up Start-up / Maintenance and cleaning / Disposal
Switching the luminaire on / off
You have the possibility of operating the luminaire
from an ordinary wall switch or switching it on and
off using the supplied remote control unit.
Switching the luminaire on / off using the
remote control unit:
– The wall switch is in basic position (OFF).
Activate the wall switch (ON)
Press the ON button of the remote control unit 9
to switch on the luminaire.
Press the OFF button of the remote control unit 9
to switch off the luminaire.
Switching the luminaire on / off using the
wall switch:
– The wall switch is in basic position (OFF).
Switch on the luminaire by activating the wall
switch (2–3 switch cycles). The luminaire can
subsequently be switched on and off via the
wall switch or the remote control unit
9 .
Fault correction: If the remote control unit 9
does not respond after switching on the luminaire,
first activate the wall switch to switch off the lumi-
naire. Then wait for 15–20 seconds and repeat the
2nd point under "Switching the luminaire on / off via
the wall switch". If after switching on the luminaire
again via the remote control unit
9 the luminaire
still does not respond, check the batteries in the re-
mote control unit
9 .
Changing the bulb
CAUTION! DANGER OF ELECTRIC SHOCK!
To replace the bulb, first disconnect the luminaire from
the mains circuit. To do this, remove the fuse or switch
off the circuit breaker in the fuse box (0 position).
CAUTION! DANGER OF BURN INJURIES!
Allow the luminaire to cool completely.
Replace the bulb 16 only after it has fully
cooled.
Turn the defective bulb 16 carefully anticlock-
wise out of the bulb socket 12 .
Use a clean, lint-free cloth to replace a bulb.
Only use 220–240 V∼ energy-saving bulbs
with an E14 base and a maximum power out-
put of 9 watt.
Screw the new bulb 16 into the bulb socket
clockwise. Check for proper seat.
Maintenance and cleaning
CAUTION! DANGER OF ELECTRIC SHOCK!
To clean the luminaire, first disconnect it from the
mains circuit. To do this, remove the fuse or switch
off the circuit breaker in the fuse box (0 position).
CAUTION! DANGER OF ELECTRIC SHOCK!
For electrical safety reasons, never clean the luminaire
with water or other fluids nor immerse it in water.
CAUTION! DANGER OF BURN INJURIES!
Allow the luminaire to cool completely.
Do not use solvents, benzene or similar subs-
tances. They could damage the luminaire.
Only use a dry, lint-free cloth for cleaning.
Disposal
The package and packaging materials consist enti-
rely of environmentally friendly materials. They can
be disposed of at your local recycling facility.
The symbol of the dustbin with the line
through it means that in the European
Union the product must be disposed of
in a separate trash collection. This applies to the
product and to all components bearing this symbol.
Products marked in this manner must not be disposed
of along with normal household waste, but rather
must be taken to a recycling collection point for
electrical and electronic appliances. Recycling helps
to reduce the consumption of raw materials and
protects the environment.
Batteries must not be disposed of in the household
trash! Return batteries and / or the device to a a lo-
cal recycling facility.