Operation weighing (fig. a), Incremental weighing (fig. a), Setting the time (fig. a) – Silvercrest Z31246A Z31246B Benutzerhandbuch
Seite 11
11
GB/IE
Operation
Weighing (Fig. A)
If the scale is in the time mode
5
, press the MODE button
3
once to switch into the weighing mode.
Note: Shortly before the scale switches into the weighing
mode, the scale shows “HELO” in the display for 1–2 sec-
onds.
1. Place the kitchen scale on a solid, flat surface.
2. Press the MODE button
3
once to change the weight
unit indicator (g / lb’oz).
3. Place the substance to be weighed on the scale. The
weight of the substance being weighed is shown in the
LC display
1
.
Incremental weighing (Fig. A)
1. Follow steps 1 to 3 of the section on “Weighing” and
press the TARE button
2
. The LC display
1
shows 0
and the TARE symbol
8
appears.
2. Add another substance to be weighed to the scale. The
LC display
1
shows the weight of the newly added sub-
stance.
3. If you remove the added substance from the scale, the
LC display
1
shows 0.
4. If you remove all of the substances to be weighed from
the scale, the LC display shows a negative value
9
.
5. Press the TARE button
2
once and the TARE symbol
8
ceases to be displayed.
6. Activate the TARE function only within a range of 3–2,500 g.
If there is no substance to be weighed on the scale and if 60
seconds elapses without a button being pressed or no movement
Insert 4 x 1.5 V AAA batteries into the battery compart-
ment
4
.
Note: Make sure you fit the batteries the right way round
(polarity). The correct polarity is shown inside the battery
compartment
4
.
Close the battery compartment
4
.
Setting the time (Fig. A)
After you have inserted the batteries, the scale switches auto-
matically into the time mode
5
. As soon as the scale has
switched into the time mode
5
, the minute value flashes in
the LC display
1
. In this event, skip the next two steps.
If the scale is in the weighing mode, press and keep pressed
the MODE button
3
for 3 seconds to switch into the time
mode
5
.
Press and keep pressed the TARE button
2
to set the time.
Press the MODE button
3
to set the desired minute value.
Press and keep pressed the MODE button
3
to speed up
the value-setting process.
Press the TARE button
2
to confirm your setting. Then the
hour value flashes.
Press the MODE button
3
to set the desired hour value.
Press and keep pressed the MODE button
3
to speed up
the value-setting process.
Press the TARE button
2
to confirm your setting.
Note: If you do not press another button within 30 seconds,
the set value stops to flash and the time is set.