Silvercrest SHLF 2000 A1 - Handbuch (Seite 10)

8
5. Select a location where the flow of hot
air is not directly aimed at people,
animals or plants.
6. Plug the mains plug into a wall socket
that complies with the technical data.
Note: The appliance consumes up to
10 amperes of current (2,000 watts). If
you have plugged other power
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.
5.2 Inserting the battery
If the appliance is new or the battery in the
remote control is flat, a new type CR2032
battery must be inserted.
1. Press the catch
towards the
middle and pull
out the battery
compartment.
2. Remove the old
battery if present.
Note: Please observe the instructions
for disposal (see “9.2 Disposable/
rechargeable batteries” on page 11).
3. Insert a new battery.
Note: Ensure the correct polarity (+/–)
when inserting the battery. The correct
polarity is marked on the battery
compartment. The negative pole of the
battery must point upwards.
4. Slide the battery compartment back in
again.
6. Operating
6.1 Displays
The selected function is shown in the
display 10.
A Swivel function is switched on
B Automatic mode. The appliance
automatically adjusts the heat output to
the room temperature. The appliance
switches off as soon as the room
reaches the required temperature.
C Low heat. The appliance operates at
1000 watts
D High heat. The appliance operates at
2000 watts
E Operating time
F Display of room temperature
G Display of set required temperature
As soon as the appliance is working the
indicator light 18 comes on.
6.2 Remote control
The appliance can be operated using the
control panel 2 or the remote control 19.
The numbers in the text below refer to the
control panel 2 and the remote control 19.
–
F
A B C D
E
G
RP89886 Heizlüfter mit LCD und FB LB6 Seite 8 Donnerstag, 23. Mai 2013 6:24 18