Silvercrest SDKT 1.76 A1 Benutzerhandbuch
Seite 12
SilverCrest SDKT 1.76 A1
10 - English
Power adapter
Please only use the supplied power adapter for the base. Never connect the power adapter to other
devices. Plug the power adapter into a suitable and easily accessible power socket only. Do not hold
the power adapter with wet hands as there is danger of electric shock. Under the following
circumstances the power adapter must be unplugged from the mains:
in any dangerous situation
when the power adapter emits unusual noise or smoke
when a storm and/or thunderstorm with risk of lightning approaches
when the power adapter or the power cord have been damaged
when the power adapter has been exposed to rain, liquids or high humidity
when you wish to clean it
The power adapter even consumes electricity in the Standby mode. In order to completely
disconnect the device from the mains, the power adapter must be pulled out from the wall outlet.
Please follow these instructions to avoid potential risk of fatal injury or fire! Never cover the power
adapter, otherwise there is a risk of fire.
Rechargeable Batteries
Insert the rechargeable batteries with the correct polarity. Never throw any rechargeable batteries into
fire. Remove the rechargeable batteries if the device is not going to be used for a long time. Improper
use may cause explosions and a risk of leakage.
Batteries must never be opened or deformed. Otherwise any leaking battery fluids may cause injuries. If
the battery fluid becomes in contact with your skin or eyes, rinse with plenty of fresh water immediately
and seek medical aid.
Never use conventional (non-rechargeable) batteries instead of the rechargeable batteries. Only use
rechargeable batteries of the same type.
Rechargeable batteries must be disposed of at specific collection points.
Cables
Unplug all cables by holding the plugs and never pull on the cables themselves. Never place pieces of
furniture or other heavy objects on the cables and take care that these do not become damaged,
especially at the plugs and sockets. Never tie knots in the cable and do not tie it together with other
cables. All cables should be positioned so that nobody can trip over them or be obstructed by them.