Silvercrest SHBS 500 B1 - Handbuch (Seite 10)

8 GB
6. Operation
Regardless of the charging state of the battery, the hair and beard trimmer can
always be mains-operated.
1. Before switching to mains operation, ensure that the device is switched off.
2. Connect the power unit to the connection7 of the device.
3. Insert the power unit into a readily accessible wall socket whose voltage
matches the voltage stated on the rating plate.
4. Switch on the device with the on/off switch5.
6.1 Pushing on/removing the comb attachments
WARNING! Risk of injury!
Switch off the device before replacing or changing the comb attachments.
Pushing on
• In order to attach a comb attachment, push this over the guide rails on the
side of the device onto the comb attachment fastener4, until it is heard to
click into place.
Removing
1. Figure A: To change the comb attachments, turn the device onto its back.
2. Figures B/C: Push the comb attachment1 upwards together with the slid-
er10. Push the comb attachment carefully upwards with moderate force us-
ing your thumb and index finger beyond the side locking pins. The comb
attachment is released from the comb attachment fastener4.
3. Remove the comb attachment.
6.2 Cutting hair
NOTES:
•
The hair to be dressed must be dry.
• The cutting length may deviate depending on the cutting angle.
• Place a sheet or cape around throat and neck to prevent cut-off hair from
dropping into the collar.
• Comb the hair well.
• First, start with a comb attachment with a longer cutting length and then, in
the course of the cutting process, use shorter cutting lengths step by step. Ad-
__GRA93480_B6.book Seite 8 Montag, 9. September 2013 10:41 22