Powerfix Z22855 - Handbuch (Seite 10)

GB/IE 8
J
Wear protective gloves! If they come into contact
with skin, leaked or damaged batteries could cause chemi-
cal burns; you should therefore wear suitable protective
gloves at all times if such an event occurs.
J
Avoid contact with skin, eyes, and mucous membranes. If
you come into contact with battery acid, rinse the affected
spot with plenty of water and / or consult a doctor immedi-
ately!
J WARNING! Switch the product OFF before inserting
the battery (LCD display 5 is off.)
J
Remove the battery from the device if it is not in use for a
long period of time.
J
Do not, on any account, short-circuit the terminals.
Q
Before start of operation
Q
Insert / replace battery
Tip: Flashing numbers indicate a discharged / flat battery.
Tip: When changing the battery, the LCD display
5 may
experience faults. Remove the battery and insert it again after
waiting more then 30 seconds.
j
Push open the lid to the battery compartment 8 (see Fig. B).
j
Remove the old battery.
j
Insert the new battery into the battery compartment and
ensure correct polarity (+ and -). Make sure that the plus
terminal points outwards.
j
Push the lid to the battery compartment 8 shut again
(see Fig. B).
Q
Preparing the caliper
j
Loosen the locking screw 4 so that you can move the
caliper.
j
Clean all measuring surfaces and the caliper rod. Otherwise,
faulty measuring results may occur due to, for example,
humidity.
j
Check that all keys, switches and the LCD display 5 work
correctly.
Q
Starting up the device
Q
Using the caliper
j
Loosen the locking screw 4 by turning it anti-clockwise.
j
Push the external measuring jaws 11 and the internal meas-
uring jaws 2 together.
j
Switch the LCD display 5 on by pressing the ON / OFF key 10 .