Hifionics INDUSTRIA HFI 200 A-HFI250A - Handbuch (Seite 10)

Connections & Features
10 - ENGLISH
RCA LEVEL INPUT
This Level Input is
designed for the RCA-
wires of your headunit or
any other devices with a
linear RCA output. If your
headunit is equipped with
a RCA Subwoofer Out-
put, it is recommended to
use this output.
POWER - LED
Indicates the operation mode
by lighting up in red.
LOW PASS - Controller
This controller adjusts the cut-off for the
low pass crossover. Thus the higher
frequencies will be eliminated from the
sound signal. Adjustable level is between
40Hz and 200Hz.
PHASE - Switch
This switch changes the
phasing mode from
“0˚” to “180˚”. Depending
on the location of the
Soundsystem, a phase
shift could improve the
Soundquality.
BASS BOOST -
Controller
This controller adjusts the
bass boost level from
0 - 18 dB. Please use this
controller with care!
LEVEL - Controller
This controller adjusts
the output level of the
Soundsystem from MIN
to MAX.
HIGH LEVEL INPUT
The High Level Inputs are designed for using already pre-amplified and non-linear input signals, e.g. like loudspeaker
wires, which are connected directly with your headunit. Split up a line signal wire of a already installed rear loudspeaker
and connect the split-up signal with the High Level Inputs.
WARNING: Never use the HIGH LEVEL INPUTS and RCA LEVEL INPUTS at the same time. This may get damage
the Soundsystem permanently.
IMPORTANT: Please ensure for all connections the correct polarity.
Faulty and interchanged polarity may cause malfunctions and damage.