Humax CI-5100C - Handbuch (Seite 24)

4-3. Service Searching
Enter the PIN code to access the Service Searching menu
as you access the Parental Control or Service Organising menu.
Press the button to start Service Search after setting the
parameters.
** The default PIN code is .
After setting the search parameters such as Frequency,
Symbol Rate etc.., you can manually find the services you have
selected.
Input the Frequency of the cable signal you want to find manually.
Input the Symbol Rate of the cable signal you want to find.
Select the Constellation of the cable signal you want to find. You
can select the value of 16, 32, 64, 128, 256-QAM or Auto.
You can select Yes or No. When you select “Yes”, you can find
more services using the home network. As it refer to NIT during
searching, if there is information about the frequency of other
services, it searches not only the service the user has entered
but the other services.
Service Search OSD
• If you press the button during the search, then
Service Search stops and the searching menu will appear.
• When you find all the services, the following picture appears.
• Before saving it, you can select the services you want to delete.
Found services OSD
• The picture above shows services that are found after
Manual Search.
• Use the Red( )button to mark the services that you want
to delete.
To unmark a service, select the service and press the
Red( )button again.
• Press the button to save, or press the button to exit
without saving.
• Then Service Searching menu appears again. When you exit
from all menus, the first service of the found service list is played.
E22
Guide of Main Menu
Manual Search
0 0 0 0
Frequency
Symbol Rate
Constellation
Network Search