Sharp AL-1651CS - Handbuch (Seite 154)

AL-1651CS ELECTRICAL SECTION 14 - 4
7) PC side: Double-click "Special (MCU/IMC2/Facsimile)" to develop
its sub trees, and select "Upload EEP-ROM Data Area" in the sub
trees.
8) PC side: Enter a desired file name, and select "Save."
9) PC side: When upload is completed, the complete message is dis-
played.
With the above procedure, the EEPROM data acquisition is completed.
Data acquired by the EEPROM data acquisition procedure are saved
in a file with extension of .eep.
4. Serial number setting
The serial number is set to the PC which is used for downloading. Set-
ting is required once only, and there is no need to set again when
rebooting the program.
1) PC side: Boot "Mainetenance.exe" and select "JUGARD2" in the
"Select Model" menu.
(Only to set the serial number, the PC should not be connected to
the machine.)
2) Select "Option"
→
"Serial Number Setting" on the menu bar.
3) Enter optional values to "Product Code" and "ID Code" on the menu
box.
After completion setting, press [OK] key.
4) The PC number (serial number) has been assigned.
5. Installing procedures
<USB integration maintenance program installation>
Driver installation is made on plug-and-play.
<Installation on Windows XP>
1) Main unit side: Press and hold [CA] key and [LEFT(V)] key, and turn
on the power simultaneously. (Check that "DOWNLOAD MODE" is
displayed on the LCD of the operation panel.
2) Connect the machine and the PC with a USB cable.
Product Code (P): Enter number (0 – 99)
Enter the product code of “3.”
ID Code(I): Enter number (0 – 99)
Assign an individual code to each PC uses
“MaintenanceTool.exe.”