Kompernass KH 1605 - Handbuch (Seite 6)

- 4 -
➩
Slide the cutter q over the film and all the way
to the other side.
Note:
The film will only be cut when you slide the cutter q
from left to right!
Sealing the film
Attention:
For sealing use only films made of PE-HD (Polyethy-
lene of high density). Otherwise, the sealing seam
will not be tight and the appliance could be damaged.
You can recognise films of this type by the inscription
"PE-HD" on the packaging.
Attention:
Do not heat the supplied film, for example in a water-
bath or similar. It is construed for temperatures of
a maximum of 60°C.
➩
Press simultaneously on the two unlocking
devices left
a and right i and open up the
appliance cover u .
➩
Lay the end of the film tube to be sealed over
the sealing wire
t .
➩
Place the selector switch h into the position
“Seal”.
➩
Then close the appliance cover u . Ensure that
the film tube does not slip off of the sealing
wire
t .
➩
Press down the appliance cover u on the outer
sides until it audibly clicks in at left and right.
➩
Press and hold the broad button o with both
hands until the control lamp y lights up. Hold
the button pressed down until the control lamp
goes out.
Note:
To achieve the best results, press the button o down
continuously, applying an even pressure
and using both hands.
Warning:
If the control lamp y does not go out after a maximum
of 10 seconds, the appliance is defective! Immediately
remove the plug from the wall socket. Do not attempt to
repair the appliance yourself. In this case, contact
Customer Services.
➩
Re-open the appliance cover u , as described
above, and remove the film. This is now sealed
at one end to a bag. This bag can now be filled
and the other end sealed by the same proce-
dure.
Warning:
Fill the bags in such a way that, under no circum-
stances, food remnants or fluids can run out of the
bag when sealing it and permeate into the appliance.
IB_KH1605_E2247_LB3 25.01.2008 12:53 Uhr Seite 4