Lindy 32824 - Handbuch (Seite 6)

English Manual
6
PC LED Display
PC LEDs
On - Shows which computer is connected to the PS/2 Keyboard/Mouse and Monitor
Flashing – Shows that the selected computer is either shut down or disconnected
Hub LEDs
On - Shows which computer is connected to the USB devices
Troubleshooting
Ensure that all cables are well seated. You can label all of cables with the number for each
respective computer to avoid confusion.
PC Computers
•
PC cannot find keyboard or mouse after the PC has booted up. Please make sure that
both the mouse and keyboard has been installed in Windows first before installing the
CPU Switch Lite USB.
•
Keyboard or mouse not working or not compatible with the PC, please make sure the
keyboard or mouse works when directly plugged in to the computer. If the problem
persists, please try another keyboard or mouse.
•
Mouse doesn't work in Auto Scan mode, you can press any key on the keyboard or the
button on the switch to return to the standard mode and then try the Keyboard or Mouse
again.
•
When CPU Switch Lite USB is in Auto Scan mode, the VGA monitor is displayed only
and CPU alternately (the USB Hub is not switched in auto scan mode). After you press
any key, the PC port will be selected at the same time, as you see the current PC
Screen.
•
If you apply a PS/2 keyboard to CPU Switch Lite USB’s PS/2 port and the computer fails
to boot because of a keyboard error, the PC BIOS (Basic Input Output System) needs
to be upgraded to new BIOS so the it accepts USB to PS/2 conversion. Normally, most
modern BIOS support this.
•
The recommended VGA cable distance is 5 meters maximum. Normally, the cable
length is based on driver capacity of your VGA card.
•
The recommended keyboard or mouse distance is 10 feet maximum. Normally, the
cable length is based on driver capacity of your motherboard.
•
When you switch the USB Hub from one PC to another and there are many USB
devices attached to the PC, it will take about 5~10 seconds for all USB devices to be
initialised.
Sun Microsystems Computers
If you use a Sun Microsystems with the CPU Switch Lite USB, you need to switch the console to
the Sun Microsystems before you boot up. After you finish booting SUN Microsystems, you can
switch the console to the other computer port.
If you apply a PC USB keyboard to USB hub port and a Sun Microsystems is connected to the
CPU Switch Lite USB, then the keyboard will not work correctly as there is no Sun-to-PC
keyboard mapping available. Sun-to-PC keyboard mapping is only available when using a PS/2
keyboard. You can connect Sun USB keyboard to one of USB Hub ports.
If you apply a PC USB keyboard or Sun USB keyboard to one of the USB hub ports and Sun
Microsystems are connected to this CPU Switch Lite USB, then no Hot Key function will work.