Parkside PFS710 - Handbuch (Seite 8)

9 GB/IE/CY
erly and move freely. Check for any
parts that are broken or damaged
enough to detrimentally affect the
functioning of the device. Have dam-
aged parts repaired before you use
the device. Many accidents have their origins
in poorly maintained electrical power tools.
f) Keep cutting tools clean and sharp.
Carefully maintained cutting tools with sharp
cutting edges are less likely to jam and are
easier to control.
g) Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and
advice, and the stipulations drawn up
for this particular type of device. In
doing this, take into account the
working conditions and the task in
hand. The use of electrical power tools for
purposes other than those intended can lead to
dangerous situations..
Safety advice relating
specifically to sabre saws
To avoid the danger of injury, fire and
damage to your health:
½
If you use the device outdoors, always connect
it through a residual current device (RCD) with
a maximum trip current of 30 mA.
½
Securely support the workpiece. Use clamps or
a vice to grip the workpiece firmly. This is much
safer than holding it in your hand.
½
Never support yourself by placing your hands
near or in front of the device or the workpiece
surface. A slip can result in injury.
½
If a dangerous situation arises, pull the mains
plug immediately out of the mains socket.
½
Always work with the mains lead leading away
from the rear of the device.
½
DANGER OF FIRE FROM FLYING SPARKS!
Sawing metal creates flying sparks.
For this reason, always make sure that nobody
is placed in any danger and that there are no
inflammable materials near the working area.
WARNING! NOXIOUS FUMES! Working
with harmful / noxious dusts represents a risk to
the health of the person operating the device
and to anyone near the work area.
Wear protective glasses and a dust
mask!
½
Do not saw materials containing asbestos.
Asbestos is a known carcinogen.
½
When sawing building materials, observe the
statutory requirements and the manufacturer’s
recommendations.
½
Do not work on moist materials or damp surfaces.
½
Switch the device on before you bring it into
contact with the workpiece.
CAUTION! Do not allow the blade to come
into contact with a solid object or the floor
when the device is operating – danger of kick-
back!
½
The shoe 5 must always lie against the work-
piece when the device is sawing.
½
Do not put the device down before it has been
switched off and has reached a standstill.
½
Use only sharp, defect-free blades. Replace
cracked, bent or blunt saw blades immediately.
½
Always keep the device clean, dry and free of
oil or grease.
© Original accessories /
attachments
½
Use only the accessories detailed in the operat-
ing instructions. The use of inserted tools or ac-
cessories other than those recommended in the
operating instructions could lead to you suffering
an injury.
© Information about saw blades
You can use any saw blade as long as it has the
correct shank fitting -
1 /
2
“ universal shaft. There are
different saw blades available in various lengths
designed to ensure optimum performance of every
sawing task with your sabre saw.
Note: TPI = teeth per inch / (i.e. per 2.54 cm)
Blade (wood)
11 :
Dimensions: 150 x 1.25 mm, 6 TPI
Most suitable for: Sawing construction timber,
General safety advice for electrical power tools