Electrolux ZB 264 X AUS - Handbuch (Seite 6)

g
8
; This appliance complies with the fol-
lowing EC directives:
– 73/23/EWG dated 19.02.1973 “Low
Voltage Directive“, including Direc-
tive Amendment 93/68/EWG
– 89/336/EWG dated 03.05.1989 “EMC
Directive“, including Amendment
Directive 92/31/EWG
Before using for the first time
Before you use your vacuum cleaner
for the first time you should charge
the battery for approx. 14-16 hours.
With a fully charged battery you can
vacuum for approx. 9 minutes.
Attaching the wall mounting
(Fig. A)
To attach the wall mounting select a
position near a room socket and
remote from any source of dampness.
0 Hold the mounting against the wall
and mark the points for the fastening
screws.
0 Use a drill to drill the holes for the
screws, push in the plastic plugs pro-
vided and insert the screws so that
they project by just 7 mm.
0 Position the wall mounting, lower it
over the two screws and then tighten
the screws securely.
3 The appliance can equally well be
stored standing on a table, the floor or
any other horizontal surface.
3 The wet vacuuming nozzle can be
stored in the wall mounting (Fig. B).
Charging (Fig. B)
The charger (8) may only be connected
to a power source of 230V, 50Hz.
0 Insert the vacuum cleaner into the wall
mounting (8) and check that the jack
plug (9) on the wall mounting fits cor-
rectly into the charge socket (7) on the
vacuum cleaner.
3 The charge control display (5) will
come on and charging will begin. It will
also come on if the battery is already
fully charged. Always leave your vac-
uum cleaner in the wall mounting
when not in use in order to guarantee
optimal suction power.
To return to full suction capacity once
a battery has been completely dis-
charged requires a charging period of
18 hours.
If a fully charged battery works for less
than 9 minutes it might be the result
of a build up of resistance to charging
which occurs if the vacuum cleaner is
always used only for short periods. If
this happens you should charge the
battery fully and use the vacuum
cleaner until the battery is empty.
After this recharge the battery. Repeat
this procedure if necessary.
Information: The battery should not be
charged in room temperatures below
0 °C or above 40 °C.
The charger can heat up during charg-
ing.
Using the vacuum cleaner
(Figs. C, D)
0 Remove your vacuum cleaner from the
wall mounting by pushing it straight
upwards.
Dry vacuuming
0 To switch on the appliance push the
on/off switch (6) forwards.
To switch the appliance off, push the
on/off switch backwards (Fig. C).