Zanussi ZWF 1023 - Handbuch (Seite 30)

– the machine starts its hourly countdown.
– The programme will start after the selected delay
has expired.
Cancelling the delayed start after having started the pro-
gramme:
1. Set the washing machine to PAUSE by pressing but-
ton 5.
2. Press button 6 once, the light relevant to the selected
delay goes off
3. Press button 5 again to start the programme.
The Delay Start can not be selected with DRAIN pro-
gramme.
Important! The selected delay can be changed only after
selecting the washing programme again.
The door will be locked throughout the delay time. If you
need to open the door, you must set the machine to
PAUSE (by pressing the button 5) and then wait a few
minutes. After you have closed the door, press the button
5 again.
Start the programme by pressing button 5
To start the selected programme, press the button 5, the
corresponding green pilot light stops blinking. The pilot
light corresponding to the running phase illuminates. The
appliance starts operating and the door is locked.
To interrupt a programme which is running, press the but-
ton 5: the corresponding green pilot light starts blinking.
To restart the programme from the point at which it was
interrupted, press the button 5 again. If you have chosen a
delayed start, the machine will begin the countdown.
If an incorrect option is selected, the red pilot light of the
button 5 blinks 3 times.
Interrupting a programme
Press the button 5 to interrupt a programme which is run-
ning, the corresponding green pilot light starts blinking.
Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to to cancel a programme which
is running. Now you can select a new programme.
Opening the door
After the programme has started the door is locked. If, for
any reason, you need to open it, set firstly the machine to
PAUSE by pressing the button 5. After a few minutes it
will be possible to open the door.
If the door remains locked, this means that the machine is
already heating or that the water level is too high. In any
case, do not try to force the door!
If you cannot open the door but you need to open it you
have to switch the machine off by turning the selector dial
to . After a few minutes the door can be opened (pay
attention to the water level and temperature!).
After closing the door, it is necessary to select the pro-
gramme and options again and to press button 5.
At the end of the programme
The machine stops automatically. The pilot light of button
5 and the pilot light corresponding to the just finished
washing phase go off.
The light 7.3 illuminates. After a few minutes the door can
be opened.
If a programme or an option that ends with water left in the
tub has been selected, the light 7.3 illuminates but the
door remains locked to indicate that the water must be
emptied out before opening the door. During this time, the
drum continues to run at regular intervals until the water
draining.
Follow the below instructions to empty out the water:
1. Turn the programme selector dial to .
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the
relevant button.
4. Press button 5.
At the end of the programme, the door can be now
opened. Turn the programme selector dial to to switch
the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Stand by: once the programme has finished after a
few minutes the energy saving system is enabled
with the pilot lights switched on. By pressing any button
the appliance will come out of the energy saving status.
30