AEG HK614000XB - Handbuch (Seite 10)

• Make sure that there is an access to
the mains plug after installation.
• Do not pull the mains cable to discon-
nect the appliance. Always pull the
mains plug.
• The appliance must not be connected
with an extension cable, an adapter or
a multiple connection (risk of fire).
Check that the ground connection is
in conformity with the standard and
regulations force.
• The power cable must be placed in
such a way that it does not touch any
hot part.
• Connect the appliance to the mains
with a device that lets to disconnect
the appliance from the mains at all
poles with a contact opening width of
minimum 3 mm, eg. automatic line
protecting cut-out, earth leakage trips
or fuse.
• None of a parts of the connection ca-
ble can not get a temperature 90 °C.
The blue neutral cable must be con-
nected to the terminal block label with
"N". The brown (or black) phase cable
(fitted in the terminal block contact
marked with "L") must always be con-
nected to the live phase.
8.3 Replacement of the
connection cable
To replace the connection cable use on-
ly H05V2V2-F T90 or equivalent type.
Make sure that the cable section is appli-
cable to the voltage and the working
temperature. The yellow/green earth
wire must be approximately 2 cm longer
than the brown (or black) phase wire.
8.4 Assembly
40-50 mm
55 mm
30 mm
min. 650 mm
490 mm
270 mm
1. Put the sealing gasket around the
edge of cut out.
2. Install the appliance in cut out and
push it down until it touch the kitch-
en top surface. Then remove the re-
maining gasket.
10 www.aeg.com