Zanussi ZOU234B - Handbuch (Seite 43)

Electrolux
43
Fig. 8
To perform this operation correctly, pro-
ceed as follows:
a) the decorated internal pane with a frame on the
4 sides must be reassembled so that the screen-
printing is facing outwards. The side of the pane
of glass is correct if you do not feel any roughness
near the screen printing when you pass your
fingers over the surface.
The internal pane of glass must be put back into the
right seats as shown in Fig. 8.
After the panes of glass have been reassembled in
the oven door, perform the procedure described in
point 8. in reverse to ensure they are locked.
How to clean the oven door seal
A rubber seal around the oven opening guarantees
correct operation.
Check the condition of this seal peri-
odically. If it has to be cleaned, do not
use abrasive objects or substances. If
you notice that the seal is damaged,
contact your local service centre and
do not use the oven until it has been
repaired.
)
Stainless steel or aluminium appliances:
We recommend that the oven door is only
cleaned using a wet sponge and dried after
cleaning with a soft cloth.
Never use steel wool, acids or abrasive
products as they can damage the oven surface.
Clean the oven control panel following the same
precautions.
DO NOT clean the oven door while
the glass panels are warm. If this
precaution is not observed the glass
panel may shatter.
If the door glass panel becomes chipped or has
deep scratches, the glass will be weakened and
must be replaced to prevent the possibility of the
panel shattering. Contact your local Service Centre
who will be pleased to advise further.