AEG F54030VI0 - Handbuch (Seite 30)

A1
A2
2. To disassemble the filter (A), pull
apart (A1) and (A2).
3. Remove the filter (B).
4. Wash the filters with water.
5. Put the filter (B) to its initial position.
Make sure that it assembles correct-
ly under the two guides (C).
6. Assemble the filter (A) and put it in-
to position in filter (B). Turn it clock-
wise until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
9.2 Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clog-
ged, remove remaining parts of soil with
a thin pointed object.
9.3 External cleaning
Clean the appliance with a moist soft
cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.
10. TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem. With some problems, different indica-
tors flash continuously or intermittent-
ly at the same time to show an alarm
code.
Alarm code Problem
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 1 time in-
termittently.
The appliance does not fill with water.
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 2 times in-
termittently.
The appliance does not drain the wa-
ter.
30 www.aeg.com