Machine settings – Zanussi ZTB261 Benutzerhandbuch
Seite 10
Problem
Possible cause
Remedy
Fluff filter clogged.
Clean fluff filter.
Overloading of laundry.
Observe recommended loading vol-
umes.
Ventilation slots covered up.
Uncover ventilation slots.
Residue on inside surface of drum or
drum ribs.
Clean inside surface of drum and
drum ribs.
Conductance of water at installation
site differs from standard setting of
machine.
1)
Re-programme standard setting for
degree of drying (see ‘Machine set-
tings’ chapter)
1)
.
Loading door does not close.
Filter not in place
2)
.
Install filter into place
2)
.
Drying cycle ends shortly after pro-
gramme starts.
Not enough washing loaded or wash-
ing loaded is too dry for selected
programme.
Select time programme or higher
drying level (e.g. EXTRA DRY instead
of STORAGE DRY ).
Drying cycle lasts an unusually long
time. Note: After around 5 hours the
drying cycle ends automatically.
Filter clogged.
Clean filter.
Load volume too big.
Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately spun.
1) Only dryers with conductance programming
2) Only dryers with removable filter
Machine settings
BUZZER permanent off
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE and TEXTILE
buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off.
10