AEG S41600TSW1 - Handbuch (Seite 10)

Problem Possible cause Solution
The product temperature
is too high. Let the product tempera-
ture decrease to room
temperature before stor-
age.
The room temperature is
too high. Decrease the room tem-
perature.
Water flows on the
rear plate of the re-
frigerator. During the automatic de-
frosting process, frost de-
frosts on the rear plate. This is correct.
Water flows into the
refrigerator. The water outlet is clog-
ged. Clean the water outlet.
Products prevent that wa-
ter flows into the water
collector. Make sure that products
do not touch the rear
plate.
Water flows on the
ground. The melting water outlet
does not flow in the evap-
orative tray above the
compressor. Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low. The temperature regula-
tor is not set correctly. Set a higher temperature.
The temperature in
the appliance is too
high. The temperature regula-
tor is not set correctly. Set a lower temperature.
The door is not closed
correctly. Refer to "Closing the
door".
The product temperature
is too high. Let the product tempera-
ture decrease to room
temperature before stor-
age.
Many products are stored
at the same time. Store less products at the
same time.
The temperature in
the refrigerator is
too high. There is no cold air circu-
lation in the appliance. Make sure that there is
cold air circulation in the
appliance.
10 www.aeg.com