SHARKOON SATA QuickPort Intern 6-Bay - Handbuch (Seite 2)

www.sharkoon.com
SATA QUICKPORT INTERN 4-BAY/6-BAY
Manual
Short manual:
1. Switch off your PC and disconnect the power cord.
2. Remove both side panels from your PC case.
3.
Take the mounting rail(s) out of the docking station.
4. Use the included fine thread screws to attach the HDD(s)/SSD(s) to the
mounting rail(s) (HDD/SSD connector pointing backwards).
5. Slide the mounting rail(s) back into the docking station.
6. Remove the 5.25" mounting bays’ front bezel.
7. Slide the docking station into the mounting bay.
8. Attach the docking station from both sides inside the mounting bay using
the included coarse thread screws.
9. Connect the docking station’s SATA data cables to the respective SATA
connectors on the mainboard (for further information also refer to your
mainboard’s manual).
10. Connect the power connectors on the docking station’s back side to the
matching power connectors of your PSU.
Note:
Before using the hard disk drive for the first time, it must be properly partitioned
and formatted.
Format the HDD by right-clicking COMPUTER and then selecting MANAGE. Under
Windows 7 select START, then right-click COMPUTER and then select MANAGE.
After that, select DISK MANAGEMENT. Here all formatable HDDs and drives will be
clearly displayed. Right-click the USB HDD and select PARTITION. The HDD will
probably need to be initialized, we suggest using the NTFS data system for Win-
dows PCs. Format the HDD to complete the procedure.
Make sure to select the correct hard disk drive for formatting due to all data
saved on the HDD being lost when partitioning and formatting!