Electrolux EN3487AOO - Handbuch (Seite 46)

Problem Possible cause Solution
The appliance has no
power. There is no voltage
in the mains socket. Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
The lamp does not
work. The lamp is in stand-by. Close and open the door.
"dEMo" appears on
the display. The appliance is in dem-
onstration mode. Keep pressed approxi-
mately 10 sec. the Mode
button since a long sound
of buzzer is heard and the
display shut off for a short
while: appliance start works
regularly.
The buzzer sounds. .
The door is not closed
correctly. Refer to "Door open
alarm".
Upper or lower
square is shown in
the temperature dis-
play. An error has occurred in
measuring the tempera-
ture. Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
As much as the advice does not lead to result, call the nearest brand-mark service.
7.1 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .
7.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
8. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
46 www.electrolux.com