Electrolux ENN2853AOW - Handbuch (Seite 33)

Problem Possible cause Solution
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that
there is cold air circulation.
6.1 Replacing the lamp
1
2
1. Switch off the appliance.
2. Press on the rear hook and at the
same time slide the cover in the direc-
tion of the arrow.
3. Replace the lamp with one of the
same power and specifically designed
for household appliances. (the maxi-
mum power is shown on the lamp
cover).
4. Slide the lamp cover into its original
position.
5. Switch on the appliance.
6. Open the door. Make sure that the
light comes on.
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
7.2 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.
ENGLISH 33