Vaisala GMW20 Benutzerhandbuch
Seite 5
Advertising
User’s Guide_____________________________________________________ GMW20
3
Figure 1
Cable routing
5.
Thread the power wires and output signal wire through
the center hole of the back plate. In case of surface wiring,
make (e.g.with a pliers) cut-out by removing the
attenuated part at lower edge of the back plate.
6.
Center the hole in the base over the drilled holes and
fasten the base to the surface by using the screws.
7.
Install the PCB into the base by aligning it over the latch
pins and press down the upper right corner until it snaps
into place. When using GMW21D or GMW22D, mount the
display module on top of the PCB.
8.
Proceed to the
Electrical connections
section.
Advertising