Operation, Keeping food warm, Stop’n go function (pause ii) – AMICA KMI 13290 F DE Benutzerhandbuch
Seite 60
60
Keep warm setting is an additional heat set-
ting available between „
0” and „1” and is in-
dicated on the display as „ ”
Keep warm setting is activated in the same
way as described in the section „
Switching
on the cooking zones”.
Keep warm setting is deactivated in the
same way as described in the section „
Swit-
ching off the cooking zones”.
Keeping food warm
Keep warm function allows for keeping food warm on a cooking zone. The selected cooking zone
operates at a low heat setting. Cooking zone’s heat setting is automatically adjusted so that food
temperature is kept at a constant temperature of 65°C. Thanks to this, ready to serve, warm food
retains its taste and does not stick to the pot’s bottom. This function can be also used to melt
butter or chocolate. For the keep food warm function to operate correctly, use a flat base pot or
frying pan, so that base temperature is accurately measured by the temperature sensor fitted in
the cooking zone.
The Keep Warm function can be activated for any cooking zone.
Due to a risk of the growth of microorganisms, it is not recommended to keep food warm for a
long time, so the Keep Warm function is switched off after 2 hours.
Stop’n go function (pause II)
Stop’n go function acts like a pause. The Stop’n go function simultaneously suspends opera-
tion of all cooking zones and then resumes at the heat settings that were previously set.
In order to
activate the Stop’n go function,
at least one cooking zone must be in use.
Next, touch the Stop’n go function sensor
field (
7). „II” will be shown on all cooking
zone displays (
3) and an LED pilot light will
light up above the Stop’n go function sensor
field (
7).
In order to
deactivate the Stop’n go func-
tion, touch the Stop’n go function sensor
field (
7) again. The LED pilot light will start
flashing and then touch any cooking zone
selection sensor field (
3). Cooking zone di-
splays (
3) will show the heat setting that was
previously set before activation of the Stop’n
go function.
OPERATION
1
3
2
0 1
3
3
1
7