ROTHENBERGER Handgriff ALLGAS 2000 Benutzerhandbuch
Seite 7
5
Keep the torch clean. Do not grease any parts. Oil or grease can be explosive when in contact
with oxygen.
If necessary clean the holes of the welding or heating attachments with the cleaning needles supplied. Push
these carefully in and out without twisting. Spiral drills steel wires, etc.
If the outlet end of the welding or heating attachment is damaged, it may be repaired by polishing
perpendicularly with a fine emery cloth laid on a flat surface.
Obtain help from a sevice engineer if repairs are necessary.
Connecting (Fig. B)
1
Cylinder valve for fuel gas
13
Fuel gas hose
2
Cylinder valve for oxygen
14
Oxygen hose
3
Cylinder pressure regulator for fuel gas
15
Torch handle
4
Cylinder pressure regulator for oxygen
16
Adjustment valve for fuel gas
5
Pressure adjusting valve fuel gas
17
Adjustment needle valve for oxygen
6
Pressure adjusting valve for oxygen
18
Connection nut
7
Shut-off valve for fuel gas
19
Welding, heating or brazing attachment
8
Shut-off valve for oxygen
25
Regulator mounted flashback arrestor for
a single cylinder for oxygen
9
Tapping point valve for fuel gas
26
Regulator mounted flashback arrestor for
a single cylinder for fuel gas
10
Tapping point valve for oxygen
27
Tapping point flashback arrestor for
oxygen
11
Tapping point pressure regulatorf or fuel
gas
28
Tapping point flashback arrestor for fuel
gas
12
Tapping point pressure regulator for
oxygen
Accessories
The relevant accessories and an order form can be found from page 6 onwards.
Disposal
Components of the unit are recyclable material and should be put to recycling. For this purpose registered
and certified recycling companies are available. For an environmentalfriendly disposal of the non-recyclable
parts (e.g. electronic waste) please contact your local waste disposal authority.
ENGLISH