ADAM Audio SX Series - Handbuch (Seite 9)

9 SX Manual / English
4.1 The front control panel
On the front you will find a highly sophisticated control panel
that allows for detailed fine-tuning of your loudspeakers to your
particular room acoustics and personal listening preferences.
The following tips are intended to assist you at using the
controls in the best manner.
For S1X users:
A trimmed control panel is located on the rear side of the S1X model. In addition to that, you will find
an LED on the bottom of the tweeter at the front. It indicates Power On and, in case of an overload, the
function of the protective circuit. When the speaker is switched on, the LED will flash red a few times.
This does not indicate an overload!
Please note that using the controls may have a great impact on the overall sound
characteristics of your loudspeakers. We recommend using the controls with
utmost care and only after several audio tests with familiar recordings.
4.2 Standby Switch and LEDs
The main power switch can be found on the rear of the
loudspeaker. On the front, there is a switch for Power On/
Standby. In Standby mode, the switch glows orange, in power
on mode it glows green.
To the right of the standby switch you can find
two LEDs:
• In case of an overload, the OL LED will flash red.
The protective circuit will save your speaker
from damage.
• All SX-monitors (except S1X) can be retrofitted with a 24 bit/192 kHz D/A
Converter. The D/A LED glows blue when a converter is inserted in the input on
the rear side of the speaker.
4. Speaker Adjustment
S5X
Control panel of the S5X-H Control panel of
the S3X-V