ADAM Audio Sub10 MK2 - Handbuch (Seite 9)

9 Sub10 MK2 Manual / english
On the front side you will find Indicator LEDs for the operating and standby
modes. Controls for the satellite filter, phase switch, signal on/continous
mode and Sub Level/Filter are located on the rear panel of the subwoofer.
The following tips are intended to assist you at using the controls in the best
manner.
5.1 LEDs
There are two LEDs on the front indicating either
operating or standby mode. In case the subwoofer
receives an overload the lower LED will flash red
indicating the function of the protective circuit.
5.2 Controls on the rear panel
a) Mode
This push button allows you to choose between
• Signal On: woofer starts operation as soon as a
musical signal arrives, and stops after 15 minutes
without a signal.
• Continuous: the unit is permanently working.
We recommend the ”Signal on” position. It
minimises power consumption and makes handling
very easy.
b) Subwoofer Phase
With the Phase Switch you can alter the phase of the subwoofer
relative to the satellites. That means to change the polarity of the bass
unit. Depending on the distance between woofer and satellites, either
0° or 180° may be the better position. We recommend to try out what
position sounds better within your system.
5. Controls
On
Standby - Protect
Sub10