Festo PF-...-SLT Монтаж - Handbuch (Seite 2)

1. Parts list
1 mini slide
2 elastic cushioning
3 cushioning
PF-...-SLT
4 slotted head
screwdriver
6 tweezers if
necessary
Warning
Make sure that assembly is carried out when the device is in a pressure
less state. Otherwise there is a danger of fingers being squashed.
Please note
Note that the cushioning may be damaged during dismantling.
Please note
If cushioning type PF-...-SLT is used in a pressure less state or if
it is not mounted in a horizontal position, make sure that the slide
(with fastened mass) does not move uncontrolled into the end
positions. The guide will otherwise be overstrained.
Please note
Make sure that cushioning type PF-...-SLT is used only at low speed
and with small masses and that the maximum permitted power is not
exceeded.
Maximum permitted power values:
Piston ∅
[mm]
6 10 16 20 25
Ezul [Nm] 0.0005 0.007 0.015 0.030 0.060
2. Retrofit cushioning type PF-...-SLT as follows:
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Please note
When cushioning type PF-...-SLT has been fitted, check the end
positions. If necessary, adjustment must be carried out in accordance
with the operating instructions (chapter “Commissioning“).
Montageanleitung (de)
685 408/ 2004-06a
†‡
Cushioning
PF-…-SLT Festo AG & Co. KG
Postfach
Ruiter Straße 82
73726 Esslingen
++49/(0)711/347-0
www.festo.com
1
2
3
4
5
4
2
1
3
1
5
3
1
1
4
2
1
1
3
1