Prior to first use of water dispenser c – Blomberg KFD 9952 XD A+ Benutzerhandbuch

Seite 16

Advertising
background image

EN

15

The water filter must be removed as

shown in the figure when it is going to

be replaced or when it will no longer

be used and by-pass cover must be

attached. It must be made sure that

Ice Off mode is active before taking it

out.

A

Caution: Water filter cleans some

foreign particles in the water. It does

not purify water from microorganisms.

A

Caution: Ice Off button must always

be pressed during replacement of the

water filter or installing the by-pass

cover.

Prior to first use of Water

Dispenser

C

Water mains pressure must not be

below 1 bar.

C

Water mains pressure must not be

above 8 bars.

C

Pumps must be used in case the

supply water pressure drops below 1

bar or if a jug is going to be used.

C

Water system of the refrigerator

must be connected to the cold water

line. It must not be connected to hot

water line.

C

No water may be obtained in the

initial operation of the refrigerator. This

is caused by the air in the system. To

discharge air from the system, press

Dispenser latch for periods of 1 minute

until water comes from the Dispenser.

Water flow may be irregular in the

beginning. Irregular water flow will be

normalized after the air in the system is

discharged.

C

At the initial startup of the

refrigerator approx.12 hours must pass

before cold water can be obtained.

C

Water mains pressure must be

between 1-8 bars for the operation

of Ice/Water Dispenser smoothly. For

this, check that 1 glass of water (100

cc) can be filled in 10 seconds.

C

The first 10 glasses of water should

not be consumed.

C

Approximately the first 30 cubes

of ice to be obtained from the Ice

Dispenser must not be used.

C

Always use the water filter when a

jug is not being used.

Advertising