Smartcore, Capacity indicator – Lupine FastClick Batteries Benutzerhandbuch
Seite 2
SmartCore
SmartCore
www.lupine.de
5 x
= 100 %
4 x
= 80%
3 x
= 60%
2 x
= 40%
1 x
= 20%
Capacity Indicator
Audible:
To check the capacity, simply press the
touch-pad once. At first an audible sig-
nal will sound, which is especially useful
while using the battery mounted on
a helmet or headband, to give a quick
reading in 20% steps.
Visible:
The visible indicator uses 5 red LEDs. The LEDs can operate in two different
operating states: blinking and continuous. LED meanings:
A blinking LED
is indicating a 10% step and a continuously glowing LED a 20% step.
Example:
3 LEDs
steady glow
(20 %, 40 %, 60 %)
1 LED
blinking
(80 %)
= 70 % remaining capacity
Taillight
To run the taillight simply
press the touch pad two times second-by-second
and the 5 LEDs will operate continuously. To switch off the taillight, simply
press the pad again.
Moving light:
Press the touch pad three times
second-by-second
to activate the moving
light. To switch it off
Note:
The capacity indicator will fade out within a few seconds. If it does not,
eventually the taillight was activated and the 5 glowing LEDs do by far not
mean the battery is fully charged.