faytech 15'' IP65 Touch Monitor - Handbuch (Seite 39)

39
Display Connection
Each cable is labeled for easy connection. To operate your faytech display properly, there
must be at least one signal source and a power source connected. To use the touch function
please connect the USB cable to your PC.
TO CONNECT THE SIGNAL SOURCE,
you have the following options:
 On a PC: Connect the VGA cable from the faytech monitor to the VGA output of your PC
graphics card. Please select SOURCE VGA, so you have an image on the display. (VGA
version.)
 On a PC: If you have a HDMI/DVI output on your PC please use the HDMI-port of the
faytech touch-monitor, with DVI you need a DVI to HDMI connector (HDMI version.)
 To DVD-Player/camera/Video source: Connect one video input to a corresponding video
source. Please be sure to switch off the video source before you connect the cables.
Switch SOURCE to the respective channel input (AV or SV) (VGA version.)
In addition, the display has one stereo audio input for video input. Audio comes through the
speakers only if there is an image signal.
CONNECT TO POWER
You can connect the faytech display with the included 120V/220V plug or the 12V power
adapter. Insert one of these power sources into the 12-36V DC-IN.
Another alternative is to connect another 12-36V source to the DC-IN. Please pay attention not
to mix the polarity (+ is inside)! Please make secure that the power source has enough current,
at 12V 1.5A for 10” IP65 Touchscreen Monitors, 12V 3A for 10.4”-15” IP65 Touchscreen
Monitors.