Philips VR702 - Handbuch (Seite 27)

TECHNICAL ASSISTANCE (BEFORE YOU CALL AN ENGINEER)
11
Symptom Possible cause
The video recorder does not respond to any button
being pressed.
No power supply.
The chiid lock is activated.
Technical disturbance:disconnect from the mains for 30 sec.
then reconnect.
Timed recording is taking place.
No playback functions are possible No recording on the cassette.
The end of tape has been reached.
The programme number for the video recorder has not been
selected or correctly stored.
Video recorder playback quality is poor For hired recordings: use the ‘Auto-tracking’ button.
Poor quality or badly worn cassette.
Loose aerial cable/ AV-Euroconnector.
The +\®>- channel control hasn’t been properly adjusted.
Recording is not possible TV channel hasn’t been stored.
A wrong programme number has been chosen.
Cassette is protected against erasure.
Timed recording does not start Recording data is incorrect.
Clock on the video recorder isn’t correctly set.
Cassette is protected against erasure.
The end of tape has been reached.
Video recorder was in ‘Tuner mode’.
VPS is switched on but ‘ VPS-time ’ is not correct.
Remote control does not work Batteries are exhausted.
Influence from fluorescent lamps or bright sunlight.
TV/VCR selector is in TV position.
VCR1/VCR2 definition is wrong.
TECHNICAL DATA *
ACCESSORIES
GonQrat
Maino voltage
Mains Irequoncy
Power consumption
Wind/reivind time
Ambient temperature during
operation
Humidity
Dimensions
Weight
Position lor use
video resolution
Audio
12
220 to 240 V
48 to 52 Hz
22 W typical (12 W typ.in standby)
270 sec. typical for E-180
+10-^0 to +35 ^C
20% to 80%
420 X 381 X101 mm (incl. feet)
6,5 kg approx.
max. 15^ inclination on all sides
> 240 lines
20Hz - 20KHZ (< 3dB)
This product complies with the Radio Interference requirements of
the Council Directive (82/499/EEC).
* Data subject to change without notice.
Packed with this video recorder are:
• Aerial cable
• Remote control unit and batteries
• Mains cable
• Audio cable
23