Operating the receiver – AUDIOLINE Watch & Care V300 Benutzerhandbuch
Seite 22
Operating the Receiver
Check the transmitter and receiver are working properly each time before the equipment is put into
operation.
Switching the receiver on/off
Press and hold this button until the logo appears first then the image being taken by the
transmitter camera.
Press and hold the button for approx. 2-3 seconds to switch the unit off.
In the case of a low battery charge, the Power LED flashes slowly. Place the receiver in the charger
to recharge the battery pack.
Settings
With the settings menu open (long press on the menu button
), you will get to the next set-
ting by pressing the menu button briefly. For changing the relevant setting press (multiple, if necces-
sary) the buttons
on the multi function key. If no action is detected within 5 seconds, the
device returns to idle state.
Press and hold down the menu key for approx. 3 s to access the settings menu.
The display shows
.
Use
to adjust the brightness.
Press the menu key briefly.
The display shows
.
Use
to set temperature measurement to °C or °F.
Press the menu key briefly.
The display shows
Lo .
Use
to adjust the lower temperature limit.
You can adjust the upper and lower limit for the temperature monitor. An alert will occur
if the temperature becomes outside the preset temperature range. When set to “Off” the
temperature monitoring is deactivated.
The ideal temperature for a baby to sleep is 16° - 18 °C. Please set or adjust the room
temperature accordingly.
Press the menu key briefly.
The display shows
Hi .
Operating the Receiver
6