Dirt Devil Bagline M7050 - Handbuch (Seite 25)

25
3 Operating
G
Proceed as follows to attach the nozzles:
1. Switch the appliance off and pull the plug out of the
socket.
2. Remove the existing nozzle from the telescopic tube.
3. Push the desired nozzle onto the lower end of the
telescopic tube or if necessary directly onto the handle
(Fig. 9).
4. Secure the nozzles no longer required in the
accessories mount, as far as this is possible. Keep the
other nozzles safe and inaccessible to children.
3 Operating
3.1 Vacuuming
.
ATTENTION:
If you use the cylinder vacuum cleaner without an
attached nozzle, there is a greater risk of accidentally
vacuuming up objects.
Fig. 9
11
WARNING:
Check the cylinder vacuum cleaner and the power cable
before each use. A damaged appliance must never be
used. There is a risk of injury.
ATTENTION:
Only use the cylinder vacuum cleaner if all the filters are
intact, dry and inserted correctly. Make sure that none of
the openings are blocked. Otherwise, the vacuum
cleaner can become damaged.
NOTE:
Your cylinder vacuum cleaner has an overheating
protection device. It turns off automatically if it overheats.
If this happens, then turn off the cylinder vacuum cleaner
and remove the plug. Remove the cause of overheating.
Wait approx. 45 minutes. Once the cylinder vacuum
cleaner has cooled down you can switch it on again.
02_M7050_gb.book Seite 25 Donnerstag, 22. März 2007 3:23 15