Erp directive, Usa regulatory compliance, Fcc part 15 – H3C Technologies H3C WX2500E Series Access Controllers Benutzerhandbuch
Seite 10
6
These products comply with the European Low Voltage Directive 2006/95/EC and EMC Directive
2004/108/EC.
The most up to date copy of the signed EU Declaration of Conformity can be downloaded from:
ErP Directive
This product complies with the Directive 2009/125/EC and European Union Commission Regulation
1275/2008.
a) For each condition providing networked standby into which the equipment is switched by the power
management function or similar function:
— the power consumption data in Watt rounded to the first decimal place:
Type of network port
Max power in network standby/sleep mode if
only this port is used for remote reactivation
1 RJ-45 autosensing 100/1000 WAN port (IEEE
802.3 Type 100BASE-TX, IEEE 802.3u Type
1000BASE-T)
8.45 Watts
4 RJ-45 autosensing 100/1000 LAN ports (IEEE
802.3 Type 100BASE-TX, IEEE 802.3u Type
1000BASE-T)
8.47 Watts
1 SFP WAN port (IEEE 802.3z Type
1000BASE-X-SFP)
8.98 Watts
— the period of time after which the power management function, or a similar function switches the
equipment automatically into the condition providing networked standby: The product goes into Idle
mode immediately after the last packet has passed on the network.
b) the power consumption of the product in networked standby if all wired network ports are
connected and all wireless network ports are activated: 9.84 Watts.
c) guidance on how to activate and deactivate wireless network ports: See Command Reference
Guide at
USA regulatory compliance
FCC Part 15
These products have been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.